[39]
Using Hold, Conference, and Transfer
Conferencing
Placing a Call on Hold
During a call, press on the handset or on the base to place the caller on hold. If you leave a
caller on hold for more than ten seconds, the display screen will read LINE ON HOLD.
To return to the party on hold, press or on a handset or on the base. The phone returns to
the holding party.
If you have more than one handset, up to three people can participate in a conference call. A three-way conference
call consists of an outside line and two handsets. You can easily join a call already in progress.
1. Press or on the handset or on the base to join the call.
2. To hang up, return the handset to the cradle or press on the handset. From the base, press . The
other station will still be connected to the call.
[xfer/intercom] [hold]
[ /flash] [ ] [speaker]
Notes:
You can only place a caller on hold for 5 minutes. Once 5 minutes has passed, that party's line is
disconnected and the phone returns to standby.
While a call is on hold, Caller ID and Call Waiting can not be used.
[ /flash] [ ]
[]
!
!
[speaker]
[speaker]
To Next Page
Loading...
Need help?
General
