Uniden TRU 8885 Series User Manual

GETTING STARTED [26] www.uniden.com
3) Press the OK soft key. You will hear a confirmation tone.
Setting the Ring Time
Ring Time allows you to set the number of rings the caller hears before your
answering system plays the outgoing message. You can set the ring time to answer
after two, four, or six rings. If you enable the Toll Saver (TS), the answering system
picks up after two rings if you have new messages and after four rings if there are
none.
1) Enter the Answ. Setup menu, and then the Ring Time
submenu (see "Entering the Menu" on page 16).
2) Press volume up/down to select a Ring Time (Toll
Saver, 2 Times, 4 Times, or 6 Times).
3) Press the OK soft key. You will hear a confirmation tone.
Setting the Record Time
Record Time sets the duration for recording the incoming messages. You have three
record time options. The options "1 minute" or "4 minutes" set the duration for
recording the incoming messages. "Announce only" answers the call but prevents
the caller from leaving a message.
1) Enter the Answ. Setup menu, and then the Record
Time submenu (see "Entering the Menu" on page 16).
2) Press volume up/down to select Record Time
(1 Minute, 4 Minutes, or Announce Only).
3) Press the OK soft key. You will hear a confirmation tone.
4KPI6KOG
6QNN5CXGT
6KOGU
$#%- &'.'6' 1-
4GEQTF6KOG
/KPWVG
/KPWVGU
$#%- &'.'6' 1-
GETTING STARTED

Uniden TRU 8885 Series Specifications

General

Brand	Uniden
Model	TRU 8885 Series
Category	Cordless Telephone
Language	English