Unify OpenScape DECT Phone S6 Base User Manual

123
Handset
DeutschEnglish
Headset – volume correction
Change the call volume for the wired headset. In addition to the standard settings for the call
volumes, here you can compensate the audio setting characteristics of your headset.
Microphone sensitivity
Adjust the sensitivity of the microphone for the receiver or wired headset. This gives you
improved acoustics in loud environments and when there are echoes.
Earpiece and handsfree profile
Select a profile for the earpiece and handsfree mode in order to adapt the telephone as much
as possible to the surroundings. Check which is the most comfortable profile for you and your
caller.
Earpiece Profiles: High frequency or Low frequency (default setting)
Handsfree Profiles: Standard (default setting) or Reduced Echo
Ringtones
Ringtone volume
Adjust the sensor: ¤ Sensitivity Use to adjust the sensor sensitivity
Save:
¤ Save
¤ . . . Use to select Audio Settings OK Corded Hdst Boost Use
to set the volume Save
¤ . . . Use to select Audio Settings OK Mic Sensitivity OK Use to
select what the setting applies for (Earpiece / Corded headset) Use to adjust the
sensitivity Save
¤ . . . use to select Audio Settings OK Acoustic Profiles
Earpiece Profiles / Handsfree Profiles OK use to select profile
Select ( = selected)
¤ . . . use to select Audio Settings OK
Ringtones (Handset) OK Volume OK use
to select For internal calls and alarms or External Calls
use to set volume in 5 levels or in crescendo mode
(increasing volume) Save
Changes are only saved permanently in Profile
Personal.
Volume
For internal calls
and alarms:
< >
External Calls:
Back Save
Example

Unify OpenScape DECT Phone S6 Base Specifications

General

Brand	Unify
Model	OpenScape DECT Phone S6 Base
Category	Telephone
Language	English