83
Handset
DeutschEnglish
Covering the headset socket
¤ Plug the lug of the rubber cover for the
handset socket into the opening on the left
of the handset.
¤ Press down the cap of the rubber cover.
Charging the batteries
¤ Charge the batteries fully prior to first use in the
charging cradle or using a standard USB mains
adapter.
The batteries are fully charged when the power
icon disappears from the display.
As soon as power is applied to the handset, a Setup wizard starts.
Setting the display language
¤ Press the control key until the language required is selected
on the display, e.g. English press the display key OK
You can also change the display language later on in the Settings
menu.
Setting the date and time
Set the date/time so that the correct date and time can be assigned to incoming calls and to
enable the alarm to be used.
¤ Insert the batteries (for
correct +/- direction, see
diagram).
¤ Fit the battery cover from
the top.
¤ Press the cover until it clicks
into place.
To re-open the battery cover:
¤ Push down the cover.
8,5 h
The battery may heat up during charging. This is not dangerous.
After a time, the charge capacity of the battery will decrease for technical reasons.
Handsets contained in the package have already been registered to the base station.
In the event that a handset is not registered however, (indicated by Please register
handset), register the handset manually ( p. 115).
Deutsch
English
Francais
To Next Page
Loading...
Need help?
General