Unify OpenScape SL6

Entrance telephone 81
Activating control relays
The service engineer can set up a maximum of 4 control relays that enable
various equipment (for example, door opener) to be activated and deactivated.
It is possible to access a specific control relay. Depending on the configuration,
the control relays can be
• activated and deactivated automatically, or
• activated and deactivated automatically on the basis of a timer.
Prerequisite: The service engineer has set up at least one switch.
This function can also be called directly by entering the code  page 39.
Activating a control relay
Press and hold down the Talk key.
Open the system menu.
s t w Select the menu item and confirm.
s t w Select the menu item and confirm.
o Follow the user guidance system from this point onwards. Enter the required
switch code (1... 4).
a Press the End call key to end the operation.
Deactivating a control relay
Press and hold down the Talk key.
Open the system menu.
s t w Select the menu item and confirm.
s t w Select the menu item and confirm.
o Follow the user guidance system from this point onwards. Enter the required
switch code (1... 4).
a Press the End call key to end the operation.
Menu
Service?
*
90=Control Relay
On?
Menu
Service?
#90=Control Relay
Off?