Unilumin ULW III User Manual

Chapter 3 LED Display Control Setting
37
3.3.4.3 Replace Module with Flash
The module of UTWII has Flash, which can save the calibration coefficient. After
replacing the module, make sure that the receiving have read coefficient from the
Flash and save.
Click Setting on the main window and select Module Flash, as shown in following fig.
Main Window
Click Check Coefficient in Modules, the receiving card will read coefficient from
module, then Click Save Calibration Coefficient on Receiving Card
Fig 3-24 Save Calibration Coefficient on Receiving Card

Unilumin ULW III Specifications

General

Brand	Unilumin
Model	ULW III
Category	Monitor
Language	English