The settings can be found under Properties:
Figure 52
We recommend the above default settings.
The path to the folder in Figure 52, A is the location where data will be automatically downloaded by
UniLauncher.
To use UniLauncher, first connect the USB cable to the meter. Then connect it to the PC. After a few
seconds you should see a message that the meter is being connected and then a menu like in
Figure 53 - Connecting the USB cable. You can choose to start PQ Online (for configuration or
realtime analysis) or you could select download to transfer data. This is very practical and
convenient.
Figure 53 - Connecting the USB cable
The very first time you connect your meter to the PC the system needs to install some drivers. Be
patient and wait (don’t pull out the USB cable and retry to fast! It could take 30-60 seconds to do the
installation)
To Next Page
Loading...
