Page 18
* Scan “Enter Group 3”
* Scan “B7”
* Scan “0” to define “Label 0”
* Scan “S”, “T”, “A”, “R” and “T” from Full ASCII chart
* Scan “B7” to end “Label 0”
* Scan “1” to define “Label 1”
* Scan “A”, “C”, “C”, “E”, “P” and “T” from FULL ASCII chart
* Scan “B7” to end “Label 1”
* Scan “2” to define “Label 2”
* Scan “E”, “N” and “D” from Full ASCII chart
* Scan “B7” to end “Label 2”
* Scan “Exit” to quit setup
After the programming, scan “Label 0”, “Label 1” and “Label 2” listed
above will have output of “START”, “ACCEPT” and “END”
respectively. The characters defined in these labels can be ASCII
characters or Function keys.
To eliminate the definition of “Label 1”, do the following:
* Scan “Enter Group 3”
* Scan “B7”
* Scan “1” to choose “Label 1”
* Scan “B7” to end
* Scan “Exit” to exit setup
There is only total 24 characters space available for defining these three
labels. If one of the labels has been defined the output with 24
characters, the other two labels cannot be defined further.
6.2 Quick Setup
Appendix A has a quick setup chart, which gives you one-label-for-
one-function convenience to setup the scanner. To setup the scanner,
locate the label with the function you want and scan that label.
6.3 Batch Setup
If you need to configure more than one scanner, you may duplicate the
settings of the scanner (master) to the others. You can do this by
producing a set of custom setup labels derived from the master scanner
and scanning these labels configuring the other scanners.
The following label is called “Dump Settings” label. Before you scan
the label, please open a text editor application (such like, Notepad,
Word, etc.) Scan the following label, the settings of the scanner will
To Next Page
Loading...
Need help?
General
