6) Regarding climbing slopes
In regular motion control mode, the rated uphill angle is less than 20°, and in AI motion control mode,
the rated uphill angle in low gear is less than 45°, and in high gear is less than 30°. When using a larger
climbing angle (approximately equal to or greater than 45°), the robot is likely to drift sideways, and when
turning directly on steep slopes, the robot is likely to become unstable. Operators must control the robot
properly.
7) Regarding obstacle crossing
In regular motion control mode, the obstacle crossing distance is less than or equal to 20cm, and in AI
motion control mode, the obstacle crossing distance is less than or equal to 25cm. Operators should be cautious
and reduce the walking speed when crossing obstacles.
8) Regarding speed
When running on smooth terrain, please stay away from crowds.
9) Regarding foot components
The robot's foot components are consumable items, and spare foot components will be provided with the
product. Wear and tear will be more significant when running on rough terrain. If significant wear or damage
to the foot pads is observed, or if there is a noticeable increase in impact noise while walking, the foot
components should be replaced promptly to prevent abnormal movement or damage to the robot.
10) Regarding IP67 protection
Before operation, ensure that the battery interface, battery compartment interface, battery surface, and
battery compartment surface are dry and free of water. After operating in water or rainy weather, wipe the
surface of the robot clean.
11) Do not touch the robot while it is in motion! Be careful of getting fingers caught at the joints, such
as the knee joint.
To Next Page
Loading...
