Place the box on a flat surface according to the placement requirements (with the front side up), then open
the top of the box and lift the robot out in its entirety. Remove the quadruped robot, the remote control, the
charger, etc. from the box separately, place the quadruped robot flat on the flat surface, and then prepare to
power it on.
1) Only Use Unitree Robotics authentic parts and ensure that all parts are in good working condition.
2) Ensure that the firmware has been updated to the latest version.
3) The users ensures that he or she is not operating the robot while intoxicated, under the influence of
drugs, and unable to concentrate.
4) Be familiar with the characteristics of each gait mode. Be familiar with the emergency braking method
of the robot in case of instability / loss of control.
5) Ensure that there are no foreign matters (such as water, oil, sand, soil, etc.) inside the robot and its
components.
6) Ensure that the remote control module and battery pack are fully charged.
7) If the expansion interface is used, check whether the cable connection is correct.
1) Installing Battery Packs
Place the B2 on a flat surface, insert the battery pack into the battery slot on the side of the robot, paying
attention to the installation direction with the anti-reverse interface facing upward. If the battery pack cannot
be fully inserted, please adjust the orientation of the battery pack. Do not force it to avoid damaging the battery
interface and buckles. When you hear a "click" sound, the battery pack is installed. Please ensure that the
buckle is in place!
To Next Page
Loading...
