© 2023 All rights reserved, Unitree Robotics
20
Remote Control
1) Whether the remote control rocker is in the middle position and whether the rocker enters
sand and other foreign matters.
2) Check whether each key of the remote control is lagged.
Uncharged checklist
Type Main points
Remote control
1) Confirm whether the basic operation function of the rocker is normal.
2) Confirm whether the current power is sufficient
Battery Confirm whether the current power is sufficient.
Cooling fan
Listen carefully with ears to confirm that the cooling fan works normally and there is no
sound such as scratching.
Battery pack maintenance
1) Never charge the battery pack in an environment where the temperature is too high or too low
2) Never store the battery pack at room temperatures above 40°C.
3) Do not overcharge the battery pack as this will cause damage to the cells.
4) If you do not use the battery for a longer period of time, please check the remaining battery
power regularly, if the power is less than 30%, please charge the battery to 70% before continuing to
store. So as not to over-discharge the battery and damage the battery.
⚫ It is recommended to do the above inspection before each use!
⚫ If any parts are damaged and need to be replaced, please contact Unitree Robotics after-sales service in time!
FCC Statement
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates,uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
For B2 robot:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment .This equipment should be
installed and operated with minimum distance 20cm between the radiator& your body.
RF warning for Remote control :
The device has been evaluated to meet general RF exposure requirment. The device can be used in portable exposure condition
without restriction.
To Previous Page
Loading...
