Unox XFT LineMiss User Manual

START COOKING / INTERRUPT COOKING / OVEN SHUTDOWN
PREHEATING
STEP 1
1h:30 min
200°C
20% steam
STEP 2 STEP 3
30 min
100°C
60% steam
not used
Ex. SET COOKING CYCLE
1
2
22
3
4
5
6
Set a cooking cycle with the desired steps:
nQSFTTUIFCVUUPO45"354501UPTUBSUUIFDPPL-
ing cycle.
o5IF45"354501i-&%MJHIUTVQBOEBQSFIFBU-
ing cycle starts, signalled when the "PRE" LED
p MJHIUT VQ UIF EJTQMBZ TIPXT UIF UFNQFSB-
UVSFQSFWJPVTMZTFU5IFPWFOCFFQTXIFOUIF
pre-heating temperature has been reached.
qAfter placing the food inside the oven cavity
and closing the door, the rst cooking STEP
TUBSUT BVUPNBUJDBMMZ NBSLFE CZ UIF MJU VQ 
LED.
rThe cooking cycle duration countdown blinks
on the display.
 *OUIFFYBNQMF
 INJOEVSBUJPO45&1 
 NJOEVSBUJPO45&1 
 NJOEVSBUJPO45&1 
 NJOTIPXOPOUIFEJTQMBZ
s5IFOFYUTUFQTUBSUTBVUPNBUJDBMMZBUUIFFOEPG
45&1
The oven beeps to signal cooking phase end.
1SFTTUIF45"354501CVUUPOGPSTFDPOETUPJO-
terrupt the cooking cycle in advance.
To activate the stand-by mode hold the button
45"354501GPSBCPVUTFDPOETSFBDUJWBUFPODF
again by pressing the 45"354501 button.
MODIFYING PARAMETERS DURING COOKING
*GBDPPLJOHQBSBNFUFSNVTUCFNPEJöFEBGUFSUIFDPPLJOHDZDMFIBTJOJUJBUFETVDIBTDPPLJOHUJNFPSUFN-
QFSBUVSF
n repeatedly press the button until the LED corresponding to the target parameter to modify lights up;
o repeatedly press the button until the LED corresponding to the target parameter to modify lights up.
p press the buttons until setting the new desired value; the modications shall take immediate
eect without pressing any other buttons.
English


Unox XFT LineMiss Specifications

General

Brand	Unox
Model	XFT LineMiss
Category	Oven
Language	English