UP Plus 2 - Page 13

UP Plus 2
3D Printer User Manual
5.
Feed the end of the filament
Then f
eed the filament
feed about 10cm out the other end of the tube.
6.
Push the end of the filament into the print head feed
hole
as far down as it will go.
3D Printer User Manual
v 2013.10.24
Feed the end of the filament
through the filament guide.
eed the filament
through the feeder tube
, then
feed about 10cm out the other end of the tube.
Top View
Push the end of the filament into the print head feed
as far down as it will go.
Top View