UP3D P55D - Maintenance of Equipment

51 52
9.1 Daily Maintenance
/Maintenance of Equipment
09
Please pay attention to the daily maintenance of your equipment, as it can ensure
that your device executes machining commands effectively and delivers satisfacto-
ry results. Therefore, your daily maintenance of the equipment is crucial.
Please adhere to the maintenance requirements outlined for your equipment and
perform the necessary maintenance tasks. The following maintenance procedures
require simple manual operations. If you are unsure about any maintenance proce-
dures, feel free to contact technical support for guidance.
1. Clean the interior of the
machining chamber using a
cleaning brush, and finally wipe it
with a lint-free cloth.
2. Clean the tool sensor, fixture,
observation window, and tool
magazine.
1. Go to the equipment mainte-
nance interface, then calibration,
and select spindle cleaning.
2. Move the spindle to the center
position of the machining
compartment and use a
double-headed brush to clean the
spindle area.
3. Click on "Release Tool", then
remove the collet nut, place it in
the calibration rod, and insert it
into the spindle.
Clean, dust-free
cloth.
Double-headed
cleaning brush.
Contact technical
support for
remote updates
Calibration disk
Calibration rod
Clean, lint-free
cloth
1. Clean,
lint-free cloth
2. Alcohol
Double-headed
cleaning brush
Cleaning brush
Fluted nut
Cleaning cone
4. After securing the spindle
collet, rotate it counterclockwise
to remove the spindle collet.
5. Use a cleaning cone to align
the spindle bore and insert it for
rotational cleaning.
6. Use a cleaning brush to quickly
rotate and clean the spindle
collet.
7. Clean any remaining areas with
a clean cloth.
8. Reinstall the spindle collet
using the disassembly method
and rotate it clockwise to ensure it
is securely locked.
9. Click on "Clamp Tool". After that,
the equipment can be returned to
zero and used normally.
Tools used
Cleaning
cycle
Key points for cleaning
Cleaning
spots
Tools used
Cleaning
cycle
Key points for cleaning
Cleaning
spots
Work
compartment
Spindle
Collet
Spindle
Collet
Daily
cleaning
Monthly
cleaning
Monthly
cleaning
Refer to the previous section for
detailed calibration steps.
Device
Calibration
Perform
every
quarter
Regular iterations are conduct-
ed to optimize and provide you
with the best experience.
Update
Software
Firmware
We will
contact you
promptly
before
updating
1. Before cleaning the equipment,
ensure the power is turned off.
2. Dampen a clean, lint-free cloth
with alcohol.
3. Gently wipe the outer casing of
the equipment.
4. Allow the casing to air dry after
wiping.
5. Resume normal operation.
Exterior
Clean
according
to your
actual
needs