DS1098-028A 134
Enter the correct access credentials if other users were created in the NVR user menu or if the default password
was modified.
Select [Login] to access the Web interface of the device, as shown in the lower left screen.
Note:
The default password is empty if the NVR password is not enabled. The system can be used by the administrator to enable
and set a new password; for instructions, see section 3.4.8.4 - [Main Menu
SystemUsers].
4.5 LIVE INTERFACE
This is the first screen that opens after the Web Client access procedure. Here you can open/close the live preview, manually
record video on the local computer, take screen snapshots, perform PTZ control, adjust the colours, etc.
1. Channel List: This can be used to open the channel list for the quick camera function.
Click on to see the list of channels.
Click on to hide the list of channels.
Activate/deactivate the Live video stream. If the Live video stream is activated, the button is blue.
Manual Recording buttons. Click to start recording the Live video stream manually. Click again to stop recording.
Manual recordings are saved on the computer.
Manual snapshot button. Click to save a snapshot of the current Live view on your computer.
Stream button. Set the camera to use Mainstream, Substream or Mobile Stream settings. Mobile Stream is only
available for IP channels.
2. Live Video Stream options:
•
Mainstream: This can be used to view all live video using high quality mainstream video settings.
•
Substream: This can be used to view all live video using medium quality video substream settings.
•
Mobile Stream: This can be used to view all live video using lower quality video settings to save bandwidth.
Available only for IP channels.
3. Main Menus
•
Live: This can be used to view live video from the cameras.
•
Playback: This can be used to view videos recorded and saved on the NVR hard disk.
•
Remote Setting: This can be used to access the NVR setup menu functions.
•
Local Settings: Set the download destinations of the recordings and snapshots obtained through the Web Client
and select the type of video file.
1
11
8
To Next Page
Loading...
Need help?
General
