PROGRAMMING MODE
http://www.miwiurmet.com.pl e-mail:miwi@miwiurmet.com.pl
14
1.07 GENERAL OPENING CODES MODE
P
1
0
7
Parameter sets in this step determine range of using general
opening codes.
0 General opening codes turned off.
1 Function active for lock output (+CL, -CL)
2 Function active for relay output (NC-C-NO)
3 Function active for lock and relay output
(+CL,-CL and NC-C-NO)
To save entered changes press
#
.
Default settings - 3
1.08 INDIVIDUAL OPENING CODES MODE
P
1
0
8
Parameter sets in this step determine range of using general
opening codes.
0 Individual opening codes turned off.
1 Function active for lock output (+CL, -CL)
2 Function active for relay output (NC-C-NO)
3 Function active for lock and relay output
To save entered changes press
#
.
Default c settings - 3
1.09 CHANGE FUNCTION OF THE RALAY WITH ELECTRICAL
LOCK
P
1
0
9
0 - Normal work
1 - Change function
To save entered changes press
#
.
Default settings – 0
1.10 VOLTAGE LEVEL OF DOOR PHONE LINE
P
1
1
0
Parameter sets in this steo determine voltage level of door phone
line. This step is important only if system works with 7V door phone
ref. 1132/620 and ref. 1132/621. Door phone ref. 1131/520 and
ref. 1132/520 works either 12V or 7 V.
0 - 12 V door phone line
1 - 7V door phone line
To save entered changes press
#
.
Default settings – 1
2. TIME SETTINGS
2.01 ELECTRICAL LOCK-TIME OF WORKING
P
2
0
1
After pressed the
#
button on the LED display will be shown actual
programmed time in seconds. To confirm that time press
#
button
or enter number of seconds from 1 to 30s.
To save entered changes press
#
.
Default settings - 3
2.02 TIME OF CALLING SIGNAL
P
2
0
2
After pressed the
#
button on the LED display will be shown actual
programmed time in seconds. To confirm that time press
#
button
or enter new time in range from 1 to 30s.
To save entered changes press
#
.
Default settings - 5
2.03 HANDSET PICK UP TIME
P
2
0
3
In this step we are programming the maximum time for picking up
the handset.
After pressed the
#
button on the LED display will be shown actual
programmed time in seconds. To confirm that time press
#
button
or if we want to change it, just enter correct time in range from 1 to
30s.
To save entered changes press
#
.
Default settings - 20
2.04 MAXIMUM TIME OF CONVERSATION
P
2
0
4
In this step we are programming the maximum time of conversation,
after which the connection will be disconnected. After pressed the
#
button on the LED display will be shown actual programmed time in
seconds. To confirm that time press
#
button or if we want to
change it, just enter correct time in range from 30 to 120s.
To save entered changes press
#
.
Default settings - 120
To Next Page
Loading...
Need help?
General
