6-48 Using the Operation Panel
Buzzer (Alarm (Buzzer) setting)
This function uses tones to notify the user of printer operations and the
printer status. This setting is useful, for example, when the printer is
located some distance from the user.
The options available in Buzzer are as follows:
• Key Confirm. (Key confirmation tone setting)
• Job End (Job completed tone setting)
• Ready (Preparation completed tone setting)
• Error (Error tone setting)
1 Press Z while Device Common > is displayed.
2 Press U or V repeatedly until >Buzzer > appears.
Key Confirm. (Key confirmation tone setting)
When On is selected in this setting, a tone sounds each time a key is
used. The default setting is On.
1 Press Z while >Buzzer > is displayed.
2 Press U or V repeatedly until >>Key Confirm. appears.
3 Press [OK]. A blinking question mark (?) appears.
4 Select On or Off using U or V.
5 Press [OK].
6 Press [MENU]. The display returns to Ready.
Job End (Job completed tone setting)
When On is selected in this setting, a tone sounds when printing ends.
The default setting is Off.
1 Press Z while >Buzzer > is displayed.
2 Press U or V repeatedly until >>Job End appears.
3 Press [OK]. A blinking question mark (?) appears.
4 Select On or Off using U or V.
5 Press [OK].
6 Press [MENU]. The display returns to Ready.
>Buzzer >
>>Key Confirm.
? On
>>Job End
? Off
To Next Page
Loading...
Need help?
General
