Printing Operation 3-3
TCP/IP
This section describes how to enable the TCP/IP protocol.
1 If TCP/IP is set to Off, use U or V to select On and press [OK].
2 Press Z. Each time you press U or V, the selection changes.
3 Display the item you want to set and press [OK]. A blinking question
mark (?) appears while you are setting DHCP and Bonjour. A
blinking cursor (_) appears while you are setting IP Address,
Subnet Mask and Gateway.
4 Press U or V to select On or Off as the setting for DHCP and
Bonjour.
For the IP Address, Subnet Mask and Gateway settings, press
U or V to move the blinking cursor to the number you want to change
(000 to 255). Use Y and Z to move the cursor right and left.
5 Press [OK].
6 Press [MENU]. The display returns to Ready.
Note Check with your network administrator for the network
address settings.
>TCP/IP >
On
>>IP Address
000.000.000.000
>>Subnet Mask
000.000.000.000
>>Gateway
000.000.000.000
>>DHCP
Off
>>Bonjour
Off
>>Subnet Mask
0
00.000.000.000
To Next Page
Loading...
Need help?
General
