Using the Operation Panel 6-75
Admin (Administrator settings)
The administrator setting is a function that identifies the user who can use
the printer and can be used to manage users. The administrator is
authenticated by the entered administrator ID and password and can then
use the printer's security functions and Job Accounting functions.
The options available in Admin are as follows:
• ID (Administrator ID input)
• Password (Administrator password input)
• Change ID (Administrator ID change)
• Change Password (Administrator password change)
1 Press [MENU].
2 Press U or V repeatedly until Admin > appears.
ID (Administrator ID input)
You can use this to set the administrator ID. The default setting is the
numeric part of your printer's model name. If you use
CLP 3626, enter
"5300".
1 Press Z while Admin > is displayed.
2 The message display shows ID and a blinking cursor (_).
3 Press U or V to increase or decrease, respectively, the value at the
blinking cursor. Enter the specified ID. Use Y and Z to move the
cursor right and left. Enter an ID consisting of between 1 and 16
numbers.
4 Press [OK]. Proceed to the next step Password (Administrator
Password input).
Admin >
ID
_
To Next Page
Loading...
Need help?
General
