Revision history
Revision Date pages Revised contents
1 11 October 2012
CONTENTS Correction of Page
1-3-1 (3) Printing an event log : 1-3-15 to 1-3-16
Installation guide : SSD(HD-6)
1-1-2 Change of Specification
Output tray capacity / Faceup : 100 sheets to 250 sheets
1-1-3 Change of Description
“Expanded HDD (SSD)” to “SSD (HD-6)”.
1-1-8, 9 Correction of Figure 1-1-6
The position of No.11 was corrected.
1-2-4 Correction of Figure 1-2-6
The container label was changed.
1-2-6 Correction of Figure 1-2-9
1-2-7 Correction of Figure 1-2-13
1-2-8 Correction of Figure 1-2-14 and Figure 1-2-15
1-2-10 Change of Procedures
Procedures 1 and 2 were replaced.
1-3-4, 9 Addition of Description
“(83) Full page printing mode” was added.
1-3-10 Addition of Description
"OP Network Status" was added.
1-3-11 Addition of Description
"Test Page" was added.
1-4-19 Addition of Description
The check of TRA31was added.
1-4-24, 30 Addition of Description
"(15)Carrier leaking occurs." was added.
1-5-9, 10 Change of Procedures
Procedures of "(3) Detaching and refitting the MP paper
feed pulley" was changed.
1-5-31 Correction of Figure 1-5-52
Developer fan motor (Rating label) : outside to inside
2 December 2012 CONTENTS Correction of Page
1-6-2 Remarks on PWB replacement : 1-6-3
1-2-2 Form change of 9, packing position change of 12 and 13
1-3-6 Correction of "description" and "supplement" at (39).
1-3-14 Addition of Service item
“Drum heater (110V only)” was added.
1-6-2 Addition of Procedure
“Emargency-UPDATE” was added.
2-1-8 Addition of the drum heater (110V only).
2-2-7, 8 Addition of the drum heater (110V only).
2-3-6, 9, 10 Addition of the connector of YC9 (110V only).
To Next Page
Loading...
