Utax P-C2660 MFP

Default Setting (System Menu)
8-138
4 Press the OK key. The Service Setting menu
appears.
5 Press the  or  key to select [Altitude Adj.].
6 Press the OK key. Altitude Adj. appears.
7 Press the  or  key to select [Normal], [High 1]
or [High 2].
8 Press the OK key. Completed. is displayed and the
screen returns to the Service Setting menu.
MC (Main charger output setting)
This sets the output of the main charger. When print quality has deteriorated, the output of the main charger
can be changed to restore print quality.
NOTE: This menu only appears when the Altitude Adj. (Altitude adjustment setting) on page 8-137 is set to
[Normal].
Use the procedure below to set the main charger output setting.
1 In the Sys. Menu/Count. menu, press the  or 
key to select [Adjust/Maint.].
2 Press the OK key. The Adjust/Maint. menu
appears.
3 Press the  or  key to select [Service Setting].
Service Setting: a b
*********************
2 Network Status
3 Test Page
[ Exit ]
1 Service Status
Altitude Adj.: a b
*********************
2 High 1
3 High 2
1 *Normal
Sys. Menu/Count.: a b
; Document Box
< Edit Destination
*********************
[ Exit ]
= Adjust/Maint.
Adjust/Maint.: a b
*********************
2 Send/Box Density
3 Backgrnd Density
[ Exit ]
1 Copy Denst. Adj.