Utax P-C2660 MFP User Manual

Default Setting (System Menu)
8-175
8
5 Press the  or  key to select [LAN Interface].
6 Press the OK key. LAN Interface appears.
7 Press the  or  key to select the desired LAN
interface.
The available LAN interfaces are as follows:
Auto
10Base-Half
10Base-Full
100Base-Half
100Base-Full
1000Base-T
8 Press the OK key. Completed. is displayed and the
screen returns to the Network Setting menu.
TCP/IP (IPv4) Setup
Set up TCP/IP to connect to the Windows network.
Refer to Network Setup (LAN Cable Connection)
on page 2-15 about the procedures.
TCP/IP (IPv6) Setup
Set up TCP/IP (IPv6) to connect to the network. The default setting is Off.
Use the procedure below to setup the TCP/IP (IPv6) setting.
1 In the Sys. Menu/Count. menu, press the  or 
key to select [System/Network], and press the OK
key.
When you are performing user management and
have not logged in, a login screen will appear.
Then, enter the Login User Name and Login
Password to log in, and press [Login] (the Right
Select key).
LAN Interface: a b
*********************
2 10Base-Half
3 10Base-Full
1 *Auto
Sys. Menu/Count.: a b
1 Report
2 Counter
*********************
[ Exit ]
3 System/Network
Login User Name: L b
*******************
Login Password:
[ Login ]

Utax P-C2660 MFP Specifications

General

Brand	Utax
Model	P-C2660 MFP
Category	All in One Printer
Language	English