Chapter 2: Reporting codes
58 NX-8E Control Panel Installation Manual
Location 212 - LCD keypad address
Location 212 has one segment of numerical data.
Certain commands in the NX-8E require it to know the location of at least one
LCD keyupad (if one exists in the system). If your system has an LCD keypad,
we recommend that you place it in partition 1 keypad 1. This will allow Location
212 to be left at the factory default. If the LCD keypad is selected as something
other than parition 1/keypad 1, program the appropriate address in Location 212.
Table 10: LCD keypad addresses
To Next Page
Loading...
Need help?
General