5.3 SELECT WEIGHT UNIT
Press MODE to shift among kg à decimal lb à
lb/oz. à kg weight units. Refer to 4.2.1 for
internal setting procedures.
The weight unit used before power off would
be employed when the scale is turned on again.
5.4 SMART POWER SAVING FUNCTION
When this function is enable, the backlight
will be turned off when constant/zero weight
is detected and remains stable for about 10/3
seconds.
Backlight will be automatically turned on again
when a weight is detected.
5.5 SET DISPLAYED VALUE TO ZERO WHEN UNLOADED
Pressing the ON/ZERO can eliminate a positive
or negative value. After the ON/ZERO is pressed,
the ZERO INDICATOR appears.
Refer to SPECIFICATIONS for maximum zero range.
5.6 TARE OFF THE WEIGHT OF A CONTAINER
When a container is used, follow the below steps
to tare off the weight of the container and
get the net weight.
a. Remove all loads away from platter
b. Make sure that the ZERO INDICATOR is on.
c. Place the container on the platter.
d. Press TARE.
After TARE is pressed, the TARE INDICATOR would
appear.
Refer to 5.2 for weighing procedures. Weight
displayed under is the net weight of the subject
matter. Refer to SPECIFICATIONS for maximum
tare range.
5.7 CLEAR THE TARE FUNCTION
Remove all loads from platter then press TARE.
After TARE is pressed, the TARE INDICATOR would
disappear.
To Next Page
Loading...
