g. Press ON/ZERO to confirm and return to
normal operation.
Note:
No transmission will be activated if weight
detected is less than 20e.
The default data output format of the scale
is
Baud Rate = 9600
Data Bit = 8
Stop Bit = 1
Parity = None
5. INSTRUCTION FOR USE
5.1 BEFORE WEIGHING
Make sure that:
a. The plastic platter is screwed firmly and
the stainless steel platter cover is placed
on the plastic platter.
b. The scale is placed on a level and strong
surface.
c. The scale is turned on.
d. The ZERO INDICATOR is on. If not, press
ZERO/ON to set display to zero.
5.2 WEIGHING
a. Always place an object onto the platter
gently. Excessive force applied to platter
may cause damages to sensor inside scale.
b. The weight of the object would be displayed
automatically.
c. It is a good practice to remove all loads
from platter after weighing. It would
prolong the lifetime of scale.
To Next Page
Loading...
