NOTE: Data stored will be erased when the scale
is turned off.
5.11 TO CLEAR ACCUMULATED DATA FROM MEMORY
a. Press MC
b. Scale displays "TOT 0" on the WEIGHT PANEL.
0 donates no entry is saved to memory. Then,
zero weight and zero count are displayed
on the WEIGHT and TOTAL COUNT PANEL
respectively. The arrow pointing at the M+
INDICATOR (OEC & OAC) will disappear.
c. All data is cleared now.
d. The scale will return to normal operating
status 2 seconds after the accumulated data
is erased.
5.12 CHECK FUNCTIONS
This scale is equipped with Check Function to
monitor upper weight limit or upper count
limit.
5.12.1 Monitoring the Upper Weight Limit
Follow the below steps to monitor the upper
weight limit.
a. Press CHECK, scale displays CH._C on the
UNIT WEIGHT PANEL.
b. Key in the upper weight limit through the
numeric keypad and confirm by @WT/SET, or
press CLEAR to quit.
c. When @WT/SET is pressed, scale displays
CH._A and upper weight limit entered on the
UNIT WEIGHT and WEIGHT PANEL respectively.
d. Wait until the scale return to normal
operating status.
e. The upper weight limit is now stored in
memory.
NOTE: The upper weight limit stored in memory
will be erased when scale is powered off.
f. Start counting transaction. When the upper
weight limit is reached or exceeded, a
continuous audio beep alarm will be
generated.
5.12.2 Monitoring the Upper Count Limit
Follow the below steps to monitor the upper
count limit.
a. Press CHECK, scale displays CH._C on the
UNIT WEIGHT PANEL.
b. Key in the upper count limit through the
numeric keypad and confirm by NUMBER SET,
or press CLEAR to quit.
To Next Page
Loading...
