UWE P90 - Basic Functions

22
7.2 Basic functions
Body Fan
You can control the functions of the tanning device via the interior control panel during the
tanning session. It is particularly easy for you to access the basic functions.
Operating and display elements
[+] button (2-2/1)
[-] button (2-2/2)
LED (2-2/3)
The buttons control the infeed of cooling air over the body. Actuate [+] to increase the intensity
of the cooling air infeed; actuate [-] to reduce the intensity.
You can select from 3 levels. The 5 LEDs are switched on appropriately for the 3 levels.
If you would like to completely switch off body cooling,
actuate the [-] button for three seconds while on level 1. The
previously set level is retained when restarting tanning. If body
cooling was switched off, the unit starts on level 2.
Head end Fan
Operating and display elements
[+] button (2-3/1)
[-] button (2-3/2)
LED (2-3/3)
The buttons control the infeed of cooling air over the head.
Actuate [+] to increase the intensity of the cooling air infeed; actuate [-] to reduce the
intensity. You can select from 3 levels. The 5 LEDs are switched on appropriately for the 3 levels.
If you would like to completely switch off head cooling, actuate the [-] button for three seconds
while on level 1. The previously set level is retained when restarting tanning. If head cooling was
switched off, the unit starts on level 2.