V2 FLEXY2 User Manual

ENGLISH
- 16 -
STORING OF THE TRANSMITTERS
• KeepPROG.RXpresseduntiltheledL1lightens
• Releasethepush-button,theledswitchesoffanditsendsout
asequenceofsingleashingsfor5seconds:thenumberof
shortashingsshowstheselectedchannel
• ToselectthefurtherchannelspressandreleasethePROG.RX
push-buttonwithin5seconds,theledchangestypeofashing
accordingtothefollowingtable:
FULL ERASING of the TRANSMITTERS
Toperformafullerasingofthetransmittersstoredinmemorydo
thefollowing:
• Switchoffthepowersupplyofthecontrolunit,
• PressandholdpressedthePROG.RXkeyofthereceiver
• Atthesametimeturnonthepowersupplyagain.TheL1led
goeson
• ReleasethePROG.RXkey:theledL1remainsonforthe
durationoftheerasingphase(about5seconds)
• WhentheledL1turnsofftheerasingprocedureiscomplete
andthecontrolunitisreadyforanewprogramming
To perform a partial code erasing the PROG2 portable
programmer is required
ROLLING CODE FUNCTION
ItispossibletoenableandtodisabletheROLLINGCODEfunction
(normallydisabled)
• PressPROG.RXpush-button,holdingitfor8seconds.
• L1ledwillswitchoffafter8seconds.Releasethepush-button.
• L1ledstartsasequenceofashingfor5seconds:
 Singleashings g ROLLINGCODEisdisabled
Doubleashings g ROLLINGCODEisenabled
• TomodifytheparameterspressthePROG.RXpush-button
within5secondsaftertherstashingofthesequence;L1led
willashaccordingtothenewparameters.
SUBSITUTIVE TRANSMITTER
Thesubstitutivetransmitter,generatedonlybymeansof
WINPPCL,allowstoreplacebyradioatransmitterstoredinthe
receiver.
Asingletransmissionwiththespeciallyprogrammed
SUBSTITUTIVETX,nearbythereceiver,replacesthetransmitter
codewiththenewone.
RepeattheprocesswithallkeysoftheSUBSTITUTIVETX.
Example:MemorizedTXAtransmitter
Itispossibletomakethreereplacementsmaximumpercode,so
forTXAyoucannd:
TXBreplacesTXA(TXAisnolongeroperative)
TXCreplacesTXB(TXBisnolongeroperative)
TXDreplacesTXC(TXCisnolongeroperative)
• Choosethechannelyouwanttomemorizeandwithin5
secondspressandholdthepush-buttonofthetransmitter.
• TheledL1switchesoffanditswitchesonagain:thismeans
that the code has been memorized.
• Thedevicewillwaitforafurthercodetomemorizefora
maximumtimeof5seconds.
SELECTED
CHANNEL
FUNCTION N° Impulses
PROG.RX
Flashing
single double triple quadruple
CHANNEL1 START 1
•
CHANNEL2 PEDESTRIANSTART 2
••
CHANNEL3 STOP 3
•••
CHANNEL4 COURTESYLIGHT 4
••••

V2 FLEXY2 Specifications

General

Brand	V2
Model	FLEXY2
Category	Control Unit
Language	English