V2 JEDI-1000

ENGLISH
22
Press the - key,
the display shows
8
Press the key: 0 flashes
to indicate that the function
is deactivated
Press the + key to activate
the function: the display
shows
I
Press the key to save
the settings: the display
shows
8
7
.Automatic closure (default: 0 – function deactivated)
If this function is activated, the device automatically closes the door after the set period of time.
Prior to closing the door, the device emits BEEPs for 20 seconds.
Press the - key,
the display shows
7
Press the key: 0 flashes
to indicate that the
function is deactivated
Press the + key to activate
the function: the display
shows
I corresponding to
30 seconds
Select the desired pause time using the + and – keys
Press the key to save
the settings: the display
shows
7
8.Maintenance alarm (default: 0 – function deactivated)
If this function is activated, the device emits BEEPs when the motor reaches 2000 operational cycles.
This alarm may be useful for scheduling maintenance operations.
To interrupt the alarm , simply press and hold the START button for 5 seconds, or power off the device for several seconds.
Press the - key,
the display shows
9
Press the key: 0 flashes
to indicate that the function
is deactivated
Press the + key to activate
the function: the display
shows
I
Press the key to save
the settings: the display
shows
9
9.Condominium function (default: 0 - function disabled)
m CAUTION: To enable the condominium function it is necessary to activate the automatic closing
The condominium function provides the following operation logics:
1 - during the opening phase any start command is ignored
2 - during a pause a start command re-charge the pause time
3 - during the closing phase a start command causes the door movement to reverse