Vacon 100 - PARAMETERS

Installation of OPTBJ board vacon • 11
24-hour support +358 (0)201 212 575 • Email: vacon@vacon.com
3
3
Open the inner cover to reveal the option board slots and install the OPTBJ board
into slot E. Close the inner cover.
NOTE! See Chapter 4.1 for the jumper settings!
4
Using the grounding clamp for control cable included in the delivery of the drive,
ground the shield of the OPTBJ cable to the frame of the AC drive.
NOTE! Shielded cable must be used.
NOTE! Grounding must be done according to best practice.
E
3041.emf
11574A_uk
Grounding clamp for
control cable