Vacon 20 - 3.2.6 General cabling rules

48 • vacon monitoring & parameters
Tel. +358 (0)201 2121 • Fax +358 (0)201 212205
5
P2.4 Baud rate 0 8 5 811
0 = 300
1 = 600
2 = 1200
3 = 2400
4 = 4800
5 = 9600
6 = 19200
7 = 38400
8 = 57600
P2.6 Parity type 0 2 0 813
0 = None
1 = Even
2 = Odd
The Stop Bit is 2-bit
When Parity type is
0 = None;
The Stop Bit is 1-bit
When Parity type is
1 = Even or 2 = Odd
P2.7 Communication time out 0 255 10 814
0 = Not used
1 = 1 sec
2 = 2 secs, etc
P2.8
Reset communication
status
01 0 815
When Canopen E6 board has been installed, the comm. parameters are as follows
V2.1
Canopen communication
status
14004
0 = Initialising
4 = Stopped
5 = Operational
6 = Pre_Operational
7 = Reset_Application
8 = Reset_Comm
9 = Unknow
P2.2 Canopen operation mode 1 2 1 14003
1 = Driver Profile
2 = Bypass
P2.3 Canopen Node ID 1 127 1 14001
Code Parameter Min Max Default ID Note
Table 23: System parameters