Vacon 20 - System Parameters

monitoring & parameters vacon • 47
24-hour support +358 (0)201 212 575 • Email: vacon@vacon.com
5
Table 22: Easy usage menu parameters
NOTE!
* These parameters are only available in power SW FWP00001V026 included in
FW01070V010 or later version.
5.20 System parameters
P17.4
Application
access pass-
word*
0
3000
0
02362
Input the right password could
review parameter group 18.
Code Parameter Min Max Default ID Note
Software information (MENU SYS->V1)
V1.1 API SW ID 2314
V1.2 API SW version 835
V1.3 Power SW ID 2315
V1.4 Power SW version 834
V1.5 Application ID 837
V1.6 Application revision 838
V1.7 System load 839
When no field bus Option Board or no OPT-BH Board has been installed, the Modbus comm.
parameters are as follows
V2.1 Communication status 808
Status of Modbus
communication.
Format: xx.yyy
where xx = 0 - 64
(Number of error
messages) 
yyy = 0 - 999 
(Number of good
messages)
P2.2 Fieldbus protocol 0 1 0 809
0 = Not used
1 = Modbus used
P2.3 Slave address 1 255 1 810
Default setting:
None parity, 1 stop bit
Table 23: System parameters
Code Parameter Min Max Unit Default ID Note