EasyManuals Logo

Vacon NX OPTC2 User Manual

Vacon NX OPTC2
42 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
layout and connections vacon 11
24-hour support +358 (0)40 8371 150 Email: vacon@vacon.com
3
3.4 Bus terminal resistors
If Vacon is the last device of the fieldbus line the bus termination must be set. Use jumper X4 (ON po-
sition) or external termination resistors (e.g. in DSUB-9 connector). See Figure 9.
Figure 9. Using jumper X4 to set the bus termination.
X4
X1
12345
9 8 7 6
ON
OFF

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Vacon NX OPTC2 and is the answer not in the manual?

Vacon NX OPTC2 Specifications

General IconGeneral
BrandVacon
ModelNX OPTC2
CategoryIndustrial Electrical
LanguageEnglish