Need help?Do you have a question about the Vacon NX OPTC2 and is the answer not in the manual?
General| Product Type | Frequency Converter |
|---|---|
| Category | Industrial Electrical |
| Protection class | IP20 |
| Communication Protocol | RS-485 |
| Operating temperature | -10°C to +50°C |
| Storage temperature | -40 to +70 °C |
| Humidity | 95% (non-condensing) |
| Communication interface | RS-485 |
Explains various grounding methods for the RS-485 fieldbus board.
Explains how to ground the cable shield using the converter frame for effective connection.
Describes an alternative grounding method where the shield connects to ground at only one point.
Explains the necessity of bus biasing for reliable RS-485 communication.
Instructs to install the board in slot E, ensuring the grounding plate fits.
Explains how to commission the board using parameters in menu M7.
Lists RS-485 parameters like Protocol, Slave Address, and Baud Rate.
Introduces the Modbus RTU protocol as an industrial communication system.
Lists supported Modbus function codes like Read Holding Registers and Write Single Register.
Describes the mapping of Vacon variables and parameters to Modbus registers.
Explains the structure of process data fields for controlling and monitoring the drive.
Details how parameters are activated and lists supported functions.
Lists features of the N2 interface for controlling and monitoring the drive.
Lists fault codes, possible causes, and correcting measures for the RS-485 option board.
To Next Page