AV Bridge MATRIX PRO
AV Bridge Matrix Pro Manual - Document Number 342-0915 Rev C Page 55 of 68
Camera focus
Changes the focus of the specified camera nearer or farther than the current focus.
camera [1-3] focus {{near | far | stop} <1-8> | mode {auto | manual}}
Specify which camera to focus.
Move the focus nearer. Optionally specify speed as an integer from
1 to 8.
Move the focus farther. Optionally specify speed as an integer from
1 to 8.
Stop the focus movement at the current point.
Set the focus mode to automatic or manual.
Focuses camera 3 near at the default speed.
camera 1 focus far 8
Focuses camera 1 far using a speed of 8.
camera 1 focus stop
Stops the focus movement of camera 1.
camera 2 focus mode auto
Sets camera 2 to automatic focus mode.
Camera pan
Pans the specified camera to the left or right.
camera [1-3] pan {left | right | stop} <1-24>
Specify which camera to pan.
Move the camera left. Optionally specify speed as an integer from 1
to 24. Default speed is 12.
Move the camera right. Optionally specify speed as an integer from
1 to 24. Default speed is 12.
Pans camera 2 to the left at the default speed.
camera 1 pan right 20
Pans camera 1 to the right using a speed of 20.
camera 1 pan stop
Stops the pan movement of camera 1.
Camera tilt
Move the specified camera up or down.
camera [1-3] tilt {up | down | stop} <1-20>
Specify which camera to tilt.
Move the camera up. Optionally specify speed as an integer from 1
to 20. Default speed is 10.
Move the camera down. Optionally specify speed as an integer from
1 to 20. Default speed is 10.
Tilts camera 3 up at the default speed
camera 1 tilt down 20
Tilts camera 1 up using a speed of 20
camera 1 tilt stop
Stops the tilt movement of camera 1