2 Installation Manual auroMATIC 560
1 Notes on the documentation
The following information is intended to help you
throughout the entire documentation.
Further documents apply in combination with this oper-
ating and installation manual.
We accept no liability for any damage caused by non-
observance of these instructions.
Caution!
This document is not a guide for making
hydraulic connections. The appropriate docu-
ments should be referred to for this.
Other applicable documents
For the heating engineer:
– This operating and installation manual
– Operating, assembly, and installation manuals for the
additional components
1.1 Storage of the documents
Please give this operating and installation manual and
all other valid documents and auxiliary equipment to the
owner of the system. The owner shall ensure that the
manuals and auxiliary equipment are properly stored, so
that they are available whenever required.
1.2 Symbols used
Please observe the safety instructions in this installation
manual when installing the appliance.
Danger!
Immediate risk of serious injury or death.
Danger due to high voltage!
Immediate risk of serious injury or death!
Caution!
Potentially dangerous situations for the prod-
uct and environment!
Note!
Useful information and instructions.
• Symbol for a required task.
2 Description of the appliance
2.1 CE label
The CE label indicates that the controller meets the
basic requirements of the Council of Europe‘s directive
89/336/EEC for electromagnetic compatibility.
2.2 Intended use
The auroMATIC 560 controller is a state-of-the-art appli-
ance which has been constructed in accordance with
recognised safety regulations. Nevertheless, improper
use can cause serious or fatal injury to the user or oth-
ers, and the appliance or other property can be dam-
aged.
The appliance is a control system for regulating warm
water storage with solar heating, and supports reheating
with a boiler or with an electric heating rod.
Any other use or extended use is considered to be
improper. The manufacturer or supplier is not liable for
any resulting damage. The user alone bears any risk.
Intended use includes the observance of the operating
and installation manuals, and all related documents.
Caution!
Any improper use is forbidden.
3 Safety instructions and regulations
3.1 Safety instructions
The controller must be installed by a qualified engineer,
who is responsible for adhering to the existing standards
and regulations. We accept no liability for any damage
caused by failure to observe these instructions.
Danger!
Risk of fatal electric shock from touching live
connections.
Before working on the appliance, switch off the
power supply and secure it against restart.
3.2 Regulations
All wiring must be in accordance with Building
Regulations Part P, current IEE regulations, and must be
carried out by a competent person.
Use standard wires for wiring.
Minimum cross-section of wires:
– Power supply 230 V
(pump connection cable): 1.5 mm
2
– Extra-low voltage lines
(sensor wires): 0.75 mm
2
Sensor wires may not be more than 50 m long.
Connections with 230 V and sensor wires must be laid
separately if longer than 10 m.
230 V connection leads must be supplied in 1.5 mm
2
and
fastened to base using the accompanying cable clamps.
Do not use free terminals on the appliances as support
terminals for other wiring.
The controller must be installed in a dry room.
1 Notes on the documentation
2 Description of the appliance
3 Safety instructions and regulations
To Next Page
Loading...
