22 Installation Manual auroMATIC 560
6.2 Resetting system parameters to the default
settings
You can reset the system parameters and the timer pro-
grams to the default settings by pressing the program-
ming button “P” for ten seconds. Then the display flash-
es three times and all of the parameters are reset to the
factory defaults.
7 Service/diagnostic level
You can access the service/diagnostic level by simultane-
ously pressing the programming button “P” and the dial
for approx. 3 seconds.
Display Actuators/sensor values Test procedure
Collector pump 1 test Collector pump 1 on, all other actuators off
Collector pump 2 test or circulation pump test (for hydraulic
plan 1)
Collector pump 2 on, all other actuators off
Switching valve test Switching valve on, all other actuators off
Anti-Legionnaires‘ pump test Anti-Legionnaires‘ pump on, all other actuators off
Electric heating rod (EP) test Test electric heating rod on, all other actuators off
C1/C2 contact test C1/C2 contact closed, all other actuators off
Cylinder temperature display for cylinder sensor 1
Table 7.1 Actuators and sensors
6 Start-up
7 Service/diagnostic level
To Next Page
Loading...
