Supplied By www.heating spares.co Tel. 0161 620 6677
5Instructions for installation and servicing ecoTEC
increase the flexibility. If desired, an inhibitor may be
used in the system. Guidance on the use of inhibitors is
contained in these instructions.
All boilers have a built in diagnostic system which indi-
cates the operational status of the boiler. This feature
provides key information to aid commissioning and fault
finding. The data badge is fitted to the underside of the
boiler. See text of General Requirements for installation
requirements or notes.
The Valliant ecoTEC are state-of-the-art appliances
which have been constructed in accordance with recog-
nised safety regulations. Nevertheless, danger to the life
and limb of the user or third parties can still occur or
the appliance or other material assets be damaged in
the event of improper use.
The appliance is designed to generate heat for connect-
ing to hot water central heating systems and for instan-
taneous hot water supply (ecoTEC combination boilers
only). Any other use or extended use is considered to be
use other than intended. The manufacturer/supplier is
not liable for any resulting damage.
Intended use includes the observance of the operating
and installation manual and the adherence to the inspec-
tion and maintenance conditions.
Danger!
Any incorrect use is forbidden.
The appliances must be installed by a competent person,
who is responsible for adhering to the existing regula-
tions, rules and guidelines.
1.4 CE marking
The CE marking shows that the appliances comply
with the basic requirements of the following direc-
tives:
- Gas appliances directive (90/396/EEC)
- Electromagnetic compatibility directive with threshold
class B (89/336/EEC)
- Low voltage directive (73/23/EEC)
The appliances satisfy the basic requirements of the effi-
ciency directive (92/42/EEC) as condensing appliance.
- The Gas Applaince (Safety) Regulations 1992
- The boiler (Efficiency) Regulations 1993
Vaillant Ltd. supports the Benchmark initiative.
At the rear of this guide, you will find a
Benchmark gas boiler commissioning checklist.
It is very important that this is completed cor-
rectly at the time of installation, commission-
ing and hand over to the user.
1.5 Gas council numbers
Applaince Gas council numbers
ecoTEC pro 24 47-044-36
ecoTEC pro 28 47-044-30
ecoTEC plus 824 47-044-31
ecoTEC plus 831 47-044-32
ecoTEC plus 831 Propane 47-044-34
ecoTEC plus 837 47-044-33
ecoTEC plus 612 41-044-44
ecoTEC plus 615 41-044-45
ecoTEC plus 618 41-044-46
ecoTEC plus 618 Propane 41-044-51
ecoTEC plus 624 41-044-47
ecoTEC plus 630 41-044-48
ecoTEC plus 630 Propane 41-044-50
ecoTEC plus 637 41-044-49
Table 1.1 Gas council numbers
Introduction 1
To Next Page
Loading...
Need help?
General
