4 Installation
12 Installation and maintenance instructions ecoTEC plus 0020209591_01
Num-
ber
Description
1
- Expansion relief valve connector
1
- Gas connection pipe
2 - Heating flow/return connection pipe
2 - Cold water, hot water connection pipe
4 - Service valve
3
- Bag with small parts
1 Lower cover
1
Installation template
1
Condensate drain hose
1 Enclosed documentation
4.3 Transporting the product
4.3.1 General
▶ Hold the load as close as possible to your body. Do not
twist your body – instead, reposition your feet.
▶ If the unit is being lifted by two persons, ensure your
movements are coordinated during lifting.
▶ Avoid bending your upper body – do not lean forwards or
to the side.
▶ Wear appropriate cut-resistant and non-slip gloves to
protect yourself against sharp edges and maintain a safe
and secure grip.
▶ If required, get somebody to assist you in this.
4.3.2 Unloading the box from the delivery van
▶ It is recommended that two people lift the unit together.
▶ Lift the box using the straps provided.
▶ Use safe lifting techniques – keep your back straight and
bend your legs at the knee.
▶ Hold the load as close as possible to your body.
▶ If the unit is being lifted by two persons, ensure your
movements are coordinated during lifting.
▶ If required, get somebody to assist you in this.
4.3.3 Transporting the box from the delivery
point to the installation site – ground floor
▶ It is recommended that two people lift the unit together.
▶ Use safe lifting techniques – keep your back straight and
bend your legs at the knee.
4.4 Dimensions
720
20
624
160
125
188
100 100
3535
440
A
B
180
125
2
1
3
5
7
9
8
4*
6*
6*
4*
7
11 10
3
5
12
1 Flue pipe wall duct
2 Product holder
3 Heating flow (22 × 1.5
diameter)
4 Hot water connection
(15 × 1.5 diameter)
5 Gas connection
(15 × 1.5 diameter)
6 Cold water connection
(15 × 1.5 diameter)
7 Heating return (22 × 1.5
diameter)
8 R1 tundish/condensate
trap connection
9 Flue pipe connection
10 Condensate discharge
connection, 19 mm
diameter
11 Condensate trap