Vaisala HUMICAP HMW92 - Figure 4 Transmitter Parts - Inside (Analog Output Models)

User's Guide _______________________________________________________________________
16 ___________________________________________________________________ M211399EN-G
1201-006
Figure 4 Transmitter Parts – Inside (Analog Output Models)
where
1
=
Mounting base
2
=
Opening for cable (wiring from top)
3
=
Terminal label
4
=
Screw terminals
5
=
Opening for cable (wiring from behind)
6
=
Orientation arrow – should point up after the mounting base has
been installed.
7
=
Place for zip tie (for cable strain relief)
8
=
Supports
9
=
Transmitter body
10
=
DIP switches for common configuration options; see section DIP
Switches of Analog Output Models on page 20.
11
=
Rotary switch for relay setpoint (only for models with relay);
see section Relay Configuration in DIP Mode on page 21.
12
=
HTM10 module with HUMICAP
®
sensor (HMW models) or
TM10 module (TMW models, measures temperature only).
Non-Me tric
Td
0...5V
Relay On
Relay High
Custom
Relay Set P oint
Metri c
RH
0...10V
Relay O
ff
Relay Low
DIP
2
3
4
5
11
10
6
7
1
9
8
12