Chapter 3 ________________________________________________________________ Installation
VAISALA ________________________________________________________________________ 27
Installing the Mounting Base
Use the mounting holes to attach the mounting base securely. Use at least
two screws (not included). The arrow on the mounting base must point
straight up after installation. Proper orientation is important: air must
flow through the vents on the bottom and top.
1310-043
Figure 13 Installing the Mounting Base
Wiring
Connect the wiring to the screw terminals on the mounting base. The
supply voltage and terminal assignments are model-specific. Max wire
size 2 mm
2
(AWG14). You can bring the cable to the housing from
above or from behind (recommended).
After completing the wiring, connect the transmitter body over the
mounting base. Note that mounting bases are model-specific.
WARNING
-energized wires.
To Next Page
Loading...