Vaisala HUMICAP HMW92 - Test Relay Operation; Other Commands; Enable Advanced Serial Commands; Reset Transmitter

User's Guide _______________________________________________________________________
62 ___________________________________________________________________ M211399EN-G
Test Relay Operation
Use the command RTEST to test the operation of the relay. Issue the
command without parameters to end the relay test.
RTEST [state]<cr>
where
state
=
State of the relay contacts. Options are:
open
(open the relay contacts)
closed (close the relay contacts)
Example (close relay contacts):
>pass 9000
>rtest closed
Relay test mode : Closed
Example (exit relay test mode, resume normal operation):
>rtest
Relay test mode : Canceled
Other Commands
Enable Advanced Serial Commands
Use the PASS command to enable the advanced serial commands.
PASS [passcode]<cr>
where
passcode
=
Passcode to enable advanced commands is 9000.
Example:
>pass 9000
Reset Transmitter
Use the RESET command to reset the transmitter.
RESET<cr>
Example:
>reset
Resetting
HMW93 / 1.00.00.0000 / XM90
>