Vaisala Indigo 500 Series User Manual (English)

Other manuals for Vaisala Indigo 500 Series

Questions and Answers:

S
Stephanie PayneAug 10, 2025
Why is login failing on Vaisala Indigo 500 web interface?
- R
  Russell Gordon Jr.Aug 10, 2025
  If you are failing to log in to the web interface of your Vaisala Transmitter, it might be due to the transmitter's time not being set correctly. Some browsers may not accept valid browser sessions if the transmitter's time differs significantly from the browser's time. To resolve this, set the transmitter's time on the touchscreen via Menu > Transmitter > Date and time. Alternatively, you can restore the factory default settings and reconnect to the web interface. Upon reconnection, you will be prompted to provide the activation code and create new users and passwords.
D
David HernandezAug 16, 2025
What to do after a power outage on Vaisala Transmitter?
- C
  Cindy CoxAug 16, 2025
  If your Vaisala Transmitter experienced a power outage, simply wait for the transmitter to power up again, which should take a few minutes. Once it powers up, it will resume displaying measurements as before. To regain access to the web interface: first, check the current IP address of the transmitter on the touchscreen at the bottom left corner of the configuration menu. Then, reconnect to the web interface using this IP address.
I
Isaac TaylorAug 22, 2025
How to sync Vaisala Indigo 500 Transmitter touchscreen and web interface?
- L
  Luke WilsonAug 22, 2025
  If the web interface of your Vaisala Transmitter isn't displaying the same content as the touchscreen, and you've recently made changes on the touchscreen, the web page might need a refresh. Simply refresh the web page to see the updated content.
E
Erin WelchAug 28, 2025
Why Vaisala Transmitter showing no measurement data from probe?
- T
  toddkennethAug 28, 2025
  If you are not receiving measurement data from the connected probe on your Vaisala Transmitter: * Check the status indicator on the connected probe. If it's off, ensure the probe is securely connected to the probe cable connector. * If the indicator is red, the probe sensor might be faulty and need replacement. * If the indicator is blinking green, try restarting the transmitter.