Need help?Do you have a question about the Vaisala WXT532 and is the answer not in the manual?
General| Brand | Vaisala |
|---|---|
| Model | WXT532 |
| Category | Transmitter |
| Language | English |
Highlights important safety considerations throughout the manual.
Explains how the WXT530 uses ultrasonic technology for wind speed and direction measurement.
Details the RAINCAP Sensor 2-technology used for detecting and measuring precipitation.
Describes PTU sensor principles and the function of heating elements.
Guides on choosing an optimal site for installation based on WMO guidelines.
Steps for mounting, grounding, aligning, and connecting the transmitter.
Details on how to mount the transmitter onto a vertical pole mast or horizontal cross arm.
Explains the importance of grounding and how to achieve a good connection.
Information on current consumption and voltage requirements for the transmitter.
Details the pin-out and wiring for the 8-pin M12 connector.
Discusses power consumption and strategies for economical power management.
Lists available communication protocols for each serial interface.
Details commands for checking and changing communication settings.
Procedure and commands for modifying communication settings.
Lists data commands and formats for ASCII communication.
Command to request wind data messages from the transmitter.
Command to request pressure, temperature, and humidity data.
Command to request precipitation data messages.
Command to request supervisor data, including heating and voltage status.
Command for a user-configurable combined data message.
How the transmitter sends data automatically at user-defined intervals.
Automatic sending of composite data messages at user-configurable intervals.
Overview of the SDI-12 standard and its modes.
Command to initiate a measurement on a specific sensor.
Command to request measured data from the device.
How to request all parameters instantly using the aR command.
Data query and message formats for NMEA 0183 query and automatic protocols.
Command to request wind speed and direction data in MWV format.
Command to output data from all sensors except wind using XDR format.
Section dedicated to configuring wind sensor settings and data messages.
Procedure and commands for changing wind sensor settings.
Section for configuring PTU sensor settings and data messages.
Procedure and commands for changing PTU sensor settings.
Section for configuring precipitation sensor settings and data messages.
Procedure and commands for changing precipitation sensor settings.
Section for configuring supervisor message settings.
Procedure and commands for changing supervisor message settings.
Defines parameters to be included in the composite data message.
Details analog output options for WXT532, including scaling and operation.
How to specify transfer function for analog output values.
Step-by-step guide for replacing the PTU module.
Information on how to contact Vaisala technical support for assistance.
Table outlining common problems, causes, and actions for data validation.
Table detailing common communication issues and their solutions.
Provides technical data on the performance of the WXT530 Series transmitters.
Specifies range, response time, accuracy, and units for wind speed and direction.
Details operating voltage, current consumption, heating voltage, and digital outputs.
Details wiring and communication protocols for the RS-485 interface.
Explains the communication protocol for SDI-12 devices.
Explains averaging methods for wind speed/direction based on protocol and settings.
Lists general configuration parameters like supervisor settings, device address, and protocol selection.
Lists configuration parameters for PTU data controls, update interval, and units.
Lists configuration parameters for wind data controls, update interval, averaging time, units, and NMEA format.
Lists configuration parameters for precipitation data controls, update interval, and units.
Lists configuration parameters for auxiliary sensors, including averaging time and gain.
Lists configuration parameters for analog mA output, including wind speed and direction scaling.
To Next Page