Chapter 5 _______________________________________________ Wiring and Power Management
VAISALA_______________________________________________________________________ 65
Wiring Using Screw Terminals
To wire using the screw terminals:
1. Loosen the three long screws at the bottom of the transmitter.
2. Pull out the bottom part of the transmitter.
3. Insert the power supply wires and signal wires through the cable
gland(s) in the bottom of the transmitter. Cable glands are included
in the optional Bushing and Grounding Kit (222109).
4. Connect the wires according to Table 12 on page 66.
5. Replace the bottom part and tighten the three screws. Make sure
that the flat cable does not get squeezed or stuck between the top
and the funnel for the flat cable and it is properly connected. To
make sure that the radiation shield stays straight, do not tighten the
screws all the way in one go. Do not overtighten.
1509-022
Figure 33 Screw Terminal Block
To Next Page
Loading...
