Vaisala WXT532 - Supervisor Data Message Request (aR5)

Chapter 7 ___________________________________________________ Retrieving Data Messages
VAISALA_______________________________________________________________________ 91
Example of the response (the parameter set is configurable):
0R1,Dn=236D,Dm=283D,Dx=031D,Sn=0.0M,Sm=1.0M,
Sx=2.2M<cr><lf>
For information on changing the parameters and units in the response
message, see Wind Sensor on page 127.
Pressure, Temperature and
Humidity Data Message (aR2)
This command requests a pressure, temperature, and humidity data
message.
Command format: aR2<cr><lf>
where
a = Device address
R1 = Wind message query command
Dn = Wind direction minimum (D = degrees)
Dm = Wind direction average (D = degrees)
Dx = Wind direction maximum (D = degrees)
Sn = Wind speed minimum (M = m/s)
Sm = Wind speed average (M = m/s)
Sx = Wind speed maximum (M = m/s)
<cr><lf> = Response terminator
where
a = Device address
R2 = Pressure, temperature and humidity message query
command
<cr><lf> = Command terminator