Chapter 4 _______________________________________________________________ Installation
VAISALA_______________________________________________________________________ 47
Mounting on Horizontal Cross Arm
When using the optional mounting kit, alignment is needed only when
mounting for the first time.
To mount a transmitter on a horizontal cross arm:
1. Remove the screw cover.
2. Align the horizontal cross arm in south-north direction. See
Aligning on page 49.
If you cannot align the cross arm, adjust the wind direction offset
as instructed in Wind Direction Offset on page 51.
3. Mount the transmitter on the cross arm using a mounting bolt
(M6 DIN933) and a nut (M6 DIN934).
1509-067
Figure 23 Mounting Transmitter to Cross Arm (L-Profile)
1 = Nut (M6 DIN934)
2 = Mounting bolt (M6 DIN933)
3 = Screw cover
To Next Page
Loading...
