User’s Guide ______________________________________________________________________
170 _________________________________________________________________ M211840EN-C
Self-Diagnostics
Error Messaging/Text Messages
The transmitter sends a text message when certain type of errors occur.
This function works in all communication modes except in the SDI-12
mode. You may disable error messaging by using the supervisor
message aSU, S=N. See Changing the Settings (aSU) on page 146.
Examples:
0R1!0TX,Unable to measure error<cr><lf> (request of wind data
while all the wind parameters were disabled from the wind message)
1XU!0TX,Sync/address error<cr><lf> (wrong device address. Ask
the correct address with ? or ?! command.
0XP!0TX,Unknown cmd error<cr><lf>
0xUabc!0TX,Use chksum CCb<cr><lf> (wrong checksum applied to
the 0xU command)
To Next Page
Loading...
