Vaisala WXT532 - Changing Supervisor Settings (aSU)

User’s Guide ______________________________________________________________________
144 _________________________________________________________________ M211840EN-C
Supervisor Message
Checking the Settings (aSU)
Use this command to check the current supervisor settings.
Command format in ASCII and NMEA 0183: aSU<cr><lf>
Command format in SDI-12: aXSU!
The response in ASCII and NMEA 0183:
aSU,R=[R],I=[I],S=[S],H=[Y]<cr><lf>
The response in SDI-12:
aXSU,R=[R],I=[I],S=[S],H=[Y]<cr><lf>
where
a = Device address
SU = Supervisor settings command in ASCII and NMEA
0183
XSU = Supervisor settings command in SDI-12
<cr><lf> = Command terminator in ASCII and NMEA 0183
! = Command terminator in SDI-12