Chapter 3 _____________________________________________________________Installation
VAISALA
_______________________________________________________________________ 31
3. Enter the unit’s default IP address in the VNC server box and
click OK.
- MRP111: 192.168.0.10
- In SPS220, MWI210: 192.168.0.20
4. Log on to the system by entering the following information:
- Session password: Administrator
and click OK.
5. Start the RegConfig program on the unit by clicking the Start
button and selecting Run.
6. Type regconfig in the Open text box and click OK.
Information on using the RegConfig program can be found in
section RegConfig Program on page 34.
7. If you make changes with RegConfig, you will be asked if you
want to save the changes. If you select to save the changes, the
unit will restart automatically and the VNC connection will end.
8. If you did not make any changes, end the connection by clicking
Close.
Creating the Connection with HyperTerminal or
PuTTYtel
A connection with HyperTerminal is useful when you have:
- MWI210 in RT20A.
- MRP111 or MPU121/MPU112/MPU111 or MWI210 and have
forgotten the unit's IP address and therefore are not able to connect
to the unit using NetMeeting.
- Windows Vista operating system with the following cards:
MWI210, MRP111, or MPU111, and therefore unable to use
NetMeeting.
To Next Page
Loading...